－
26
－
8
－
3
．
Robotic Operations
When the screw feeder is used with an automatic assembly
system, in order to avoid contacts between screw driver and
screw feeder , please set the lowest point of the bit at least 0.3mm
above the screw, so that contact or collision of the driver bit and
screw feeder can be avoided.
8
－
2
．
Installation with Robotic System
When installed with a robotic assembly, the screw feeder shall be
fastened by lower edges of the cover. (Please refer to diagram on
the right side) Fastening screws on bottom edge of the cover can be
used for this purpose as well.
In addition, if the rubber supports shall be replaced with fastening
assemblies by the user, please keep length of the screws less than
5mm going inside the machine, in order to prevent damage to inter-
nal mechanism of the screw feeder.
Bit cover
Driver bit
Screw
0.3mm above screw
h e a d t o p r e v e n t
collision or damage to
the screw feeder.
0
.
3
Fixing
method
Fixing screws (M2.6
）
ᚋ᪉
๓᪉
Rubber foot position
Front
Back
