OHAUS 7000 Series, Instruction Manual, Page: 47 / 134

7000 SERIES INDICATORS EN 41
Assignment
Options for input assignment are:

None (default)

SICS
– S

Tare

Blank Display

SICS
– SI

Unit Switching

Clear Tare

SICS
– SIR

Zero

Print
Outputs
For each Discrete Output, menus permit an assignment to be selected from the following options:

None (default)

Motion

Over Capacity

Center of Zero

Net

Under Zero
Function Key
The Function Key setup allows selection of the application that will be active when the
FUNCTION key is pressed.
Only one application can be selected.
Assignment
Options for the assignment of the
FUNCTION key are:

Disabled (default)

Counting

Animal Weighing

Checkweighing
The next setup branches will vary based on the selection for the
FUNCTION key assignment. Depending on the
FUNCTION key selection, one of the following applications will be shown. If the FUNCTION key is disabled, none
of the application setup branches will be shown and the next parameter will be the Reset function (refer to page
43).
For details on the setup, configuration and operation of each of these applications, please refer to Chapter 4,
Applications: Configuration and Operation.
Auto Start
If the function key has been given an assignment, this parameter determines whether, when the terminal is
powered on, the display will show the application. If Disabled, on startup the terminal will be in basic weighing
mode..