OHAUS 7000 Series, Instruction Manual, Page: 49 / 134

7000 SERIES INDICATORS EN 43
Checkweighing
The following parameters are used to configure the Checkweighing application.
Figure 3-14: Application Menu
– Checkweighing
Reset
To initiate a reset of the Application branch, press the ENTER key. If the reset was successful, a verification
message that reads “Reset Successful” displays If the reset was not successful, an error message that reads
“Reset Failure” displays. If the reset fails, try to initiate the reset again. If the reset continues to fail, contact a local
OHAUS CORPORTATION representative for assistance.
Press the
LEFT navigation key to exit without resetting.
Application reset does NOT include the reset of information in Alibi Memory. This data can only be reset by
selecting Maintenance, Reset All or a Master Reset.
Checkweigh
Operation
Source
Tolerance Type
Target Editing
Display Mode
Motion Blanking
Display
Quick Set Target
Menu Keys
Target Values
Active Target
Target Table
- Tolerance, Under Limit
Target
+ Tolerance, Over Limit
Hold Timer
Motion Check
SmartTrac
Line 1
Description
Application
Target Table
Totalization
Target Table
Clear Totals
View/Edit Table