OHAUS 7000 Series, Instruction Manual, Page: 111 / 134

7000 SERIES INDICATORS EN 105
S_S_ _ _ _ _ 129.09_kg
S_S_ _ _ _ _ 129.09_kg
S_D_ _ _ _ _ 114.87_kg
. . . The scale continues to send stable or dynamic weight values
Comments
The SIR command is overwritten and cancelled by the commands S, SI, SR, and @.
The data output rate is approximately 4 per second.
Z
– ZERO
Command: Z
Response: Z_A Command performed, meaning the scale was in gross mode, scale was stable and weight
was within the zero capture range.
Response: Z_I Command understood, not executable at present.
Response: Z_+ Upper limit of zero setting range exceeded.
Response: Z_- Lower limit of zero setting range exceeded.
Comments
The calibrated zero point determined during calibration is not influenced by this command.
The terminal will wait for up to 3 seconds after receiving an “Z” command for no-motion. If motion does not settle
within this time, the command is aborted and the Z_I response is sent.
@
– RESET
Command: @
Response:
I4_A_“12345678”
12345678 Serial number of the scale
Comments
Resets the scale to the condition found after switching on, but without a zero setting being performed.
All commands awaiting responses are canceled.
The tare register is cleared.
The SIR and SR commands are cancelled.
The Reset command is always executed except that a Reset command received by the terminal during the
calibration and test procedure cannot be processed.