42
9.
Verify that the bottle has sealed correctly with the gasket as
shown in fig.
B
, , and note how the seal is insufficient or partial in fig.
C
D
, which would require readjustment or addition of another spacer
and repeating the process from step "
2
" after removing the bottle.
10.
To exit this functionality mode press the P button in the upper left
corner (fig. 1).
FOR DISPENSERS WITH MANUAL PISTONS
For the insertion of a bottle into the machine it is suggested to perform
The following operations:
1.
Make sure the machine is properly supplied either by nitrogen or
argon gas.
2.
. Insert suction tube
►
→
cap. 9.2
3.
Make sure the pad and the spacer of the piston are properly
positioned with consideration to the size of the bottle.
4.
Position the bottle according to fig.
A
5.
Manually push the piston down to facilitate insertion of the bottle
into the space provided.
6.
Gently release the piston and check that the neck of the bottle fits
snugly at the base of the tap seal.
A
Manual of Use
43
B
C
D
9.5.1 Inform the machine insertion of the bottle
in a certain position.
It serves to inform the machine that was iserita a bottle in a certain
position:
1.
Press and hold the button for a few seconds
at the bottom right
of the center display (Figure 1).
2.
We will notice that the power of the TAP LED will begin to flash.
3.
Select the nozzle where we inserted the bottle (Figure 2).
4.
Once you have selected the location, the display will start a short
animation of the bottle (Figure 3).
5.
Wait for the end of the animation.
47
Officine Gullo
