36
Planetary Final Drive Service Manual
Housing Subassembly
1.
Place housing (1G) cover-side up onto table. Install bearing cup (1C) with wide face down,
insure cup is aligned with bore. Press cup (1C) into housing using press tool. Insure that the
cup is fully seated against the bearing shoulder.
2.
Turn over the housing (1G) on the table. Install the other bearing cup (1C) with large face
down and align with the bore. Press cup (1C) into housing (1G). Insure that the bearing cup
is fully seated against the bearing shoulder.
3.
Spray seal bore with a light film of alcohol. Wipe seal bore dry. Insure there is no debris on
the seal bore surface. Apply a thin coat of RTV blue silicone sealant in the seal bore of the
housing (1G).
4.
Remove inner seal sleeve and install outer seal (1B) into housing seal bore using seal
installation Tool.
This concludes the Housing Subassembly.
Summary of Contents for Torque-Hub C014C5 Series
