Oerlikon Fairfield Torque-Hub C014C5 Series, Service Manual

Page: 31 / 52

31
8. Finish pushing the Planet Shaft (8D) into the Carrier (8A) until roll pin holes of Planet Shaft
and Carrier are aligned. If necessary, a
lign roll pin holes using a 1/8” diameter punch.
NOTE: The chamfer on the Roll Pin hole should be towards the roll pin hole in the Carrier.
9.
Drive the Roll Pin (8E) with Chamfered end into the roll pin hole in Carrier (8A) and into the
Planet Shaft (8D) until the larger end of the Roll Pin (8E) is flush with the outside diameter of
Carrier (8F).
10.
Repeat steps 5 to 9 for the remaining two Planet Gears (8F).
This concludes the Input Carrier Subassembly.