OEM DOME, User Manual, Page: 76 / 206

DOME
Maintenance
EN - 32
6.1.d - Service intervention according to the spe-
cific requirements
6.1.d.a - Lamp replacement (Fig. 4)
• Remove the stone around the burnt bulb, for the stone
dismantling procedure see the lifting oven paragraph.
• Unscrew the two screws (1) and remove the clamps
(2) with the lampholder (3).
• Remove the burnt bulb and replace it with a new
one, then reassemble it all by proceeding inversely
to disassembly.
ATTENTION
It is an halogen lamp do NOT touch with
your fingers.
6.1.d.b - How to clean the cooling fan of the switch-
board (Fig. 5)
In case the oven displays the trouble report
“TECHNICAL
COMPARTMENT/POWER BOARD
OVERHEATING”,
you shall provide cleaning the cooling fan of the
switchboard as follows:
• Remove the stone at the fan, for the stone dismantling
procedure see the lifting oven paragraph.
• Unscrew screws (1).
• Unscrew screws (2).
• Remove the grid (3) and the collect crumb bowl (4).
• Remove lid (5) and the metal plate (6).
• Loosen the two nuts (7).
• Remove the panel (8).
• Use compressed air to remove dirt deposited on the
fan (9).
DANGER
Make sure that the power to the electric
panel has been cut.
IMPORTANT
In the event the oven shows again the
aforementioned trouble report, please
contact our technical service personnel.
FIG. 4
2
3
1
FIG. 5
1
7
3
9
4
5
6
8
2