57
Inverter swimming pool heat pump
GB
Bypass installation diagram for one heat pump
Bypass installation diagram for more than one heat pump
The fi lter located upstream of the heat pump must be cleared regularly to ensure that
the circulating water is clean and to avoid any operational problems due to dirt or
clogging in the fi lter.
Hydraulic connection
3.6
13
By-Pass assembly for one heat pump
By-Pass assembly for more than one heat pump
The filter located upstream of the heat pump must be regularly cleared so that the water in the system is
clean, thus avoiding the operational problems associated with dirt or clog- ging in the filter.
Out
Automatic water
treatment system
Filt pump
TOWARDS THE POOL
FROM THE POOL
Pool
In
13
By-Pass assembly for one heat pump
By-Pass assembly for more than one heat pump
The filter located upstream of the heat pump must be regularly cleared so that the water in the system is
clean, thus avoiding the operational problems associated with dirt or clog- ging in the filter.
Out
Out
Filt pump
TOWARDS THE POOL
FROM THE POOL
Pool
In
In
Automatic water
treatment system
11
3.3 Installation layout
3.4 Connecting the condensation draining kit
While operating, the heat pump is subject to condensation. This will result in a more or less large run-off of
water, depending on the degree of humidity. To channel this flow, we recommend that you install the
condensation drainage kit.
How do you install the condensation drainage kit|?
Install the heat pump, raising it at least 10 cm with solid water-resistant pads, then connect the drainage pipe to
the opening located under the pump.
3.5 Installing the unit on noise-damping supports
In order to minimize the noise pollution associated with heat pump vibrations, it can be positioned on vibration
absorbing pads.
To do this, you simply have to position a pad between each of the unit’s feet and its support, and then fix
the heat pump to the support with suitable screws.
Open
valve
Half-open
valve
11
3.3 Installation layout
3.4 Connecting the condensation draining kit
While operating, the heat pump is subject to condensation. This will result in a more or less large run-off of
water, depending on the degree of humidity. To channel this flow, we recommend that you install the
condensation drainage kit.
How do you install the condensation drainage kit|?
Install the heat pump, raising it at least 10 cm with solid water-resistant pads, then connect the drainage pipe to
the opening located under the pump.
3.5 Installing the unit on noise-damping supports
In order to minimize the noise pollution associated with heat pump vibrations, it can be positioned on vibration
absorbing pads.
To do this, you simply have to position a pad between each of the unit’s feet and its support, and then fix
the heat pump to the support with suitable screws.
