39
1-800-68-634
Octane Fitness Confidential
3.11 Servomotor Replacement
1. Unplug the unit and remove the shrouds to access the inside. Unplug the servomotor from the cable assembly.
2. Unscrew the servomotor from the unit base using a Phillips screwdriver.
3. Notice the way that the brake cable wraps around the motor tensioning pulley, shown in Figure 3.19. Rotate the motor to
remove the brake cable end from the motor tensioning pulley.
4. Insert the brake cable end into the motor tensioning pulley of the new servomotor, making sure that it wraps correctly around
the pulley from the right, wrapping clockwise (Figure 3.18).
5. Plug the servomotor into the cable assembly and power on the unit.
6. Press the Level + button to move the resistance through levels 1 to 20, and then push Level - to move the resistance back
down through all levels. Verify that the pulley moves through the levels and that it is in the proper position at level 1, with
the notch on the pulley oriented as shown in Figure 3.18. (If it is not, contact Octane Fitness Customer service for further
assistance in making the proper adjustment.)
7. Verify that the brake cable slider is positioned at the bottom with the cable exiting the slot at the “5 o’clock” position when
the unit is at resistance level 1 (Figure 3.17). See Brake Cable Adjustment in this section for more information.
8. Re-attach the servomotor to the unit base using a Phillips screwdriver, and zip-tie the cable to the frame.
Figure 3.18
Arrow shows
direction of
pulley rotation
from level 1 to
level 20. Pulley
shown at level 1.
Correct cable installation;
cable wraps around the side
of the pulley closest to the
base of the servomotor that is
attached to the frame.
