8
Octane Fitness Confidential
1-800-68-634
SECTION III:
Part Replacement & Adjustment
Procedures
3.1
Roller Wheel Replacement
1. Verify that you have the correct wheels available. The wheels for the Q35 are a “shallow cut” style (Figure 3.1).
Contact Octane Fitness Customer Service if you need assistance identifying he proper wheels.
2. Remove two (2) Phillips screws and remove the plastic wheel cover.
3. Use a 17mm wrench to remove the bolt and the washer that holds the wheel on the axle.
4. Remove the wheel assembly. If the wheel is stuck, you may need to pry it off using a large-blade flat screwdriver
or a small pry bar.
5. Install the new wheel on the axle. If necessary, tap the wheel lightly with a rubber or hard plastic mallet to ensure
that it is seated properly.
6. Install the washer and bolt and tighten with the 17mm wrench.
7. Replace the plastic wheel cover and secure it with the two Phillips screws.
8. Wipe down the chrome rails with a dry rag. You may apply a thin coat of white lithium grease to all four rails only.
Do not apply grease to the wheels. Do not use WD-40
®
or a silicone spray. With a clean rag or paper towel, work
the grease down the rails, covering the rails with a small amount of lubricant. Remove excess grease with a dry
rag; you should be able to feel the grease but not see it.
9. Use the pedal arms to move the machine through its motion forward and backward several times to test.
Figure 3.1
