EXPLORE
E6 & E7 TH
.
INSTALL & OPERATION MANUAL
24
5
Operation / Maintenance
5.1 OPERATION
Switch Control
The Switch Control mode allows the user to switch between colours and strobe modes using a push switch.
The sequence for the Explore E6 & E7 TH Dual White/Blue is a closed loop as follows:
1. Solid White
(default stage after power cycling)
2. Solid Blue
3. Fade White / Blue
4. Strobe Blue
5. Strobe White
6. Strobe White / Blue
7. 50% White and 50% Blue
After step 7 the next button press will reset the sequence back to step 1.
The sequence for the Explore E6 & E7 TH Colours DMX is a closed loop as follows:
1. Solid Chosen Colour
(default stage after power cycling
– last chosen colour stored)
2. Strobe Chosen Colour
3. Colour Cycle
If during the colour cycle (step 3), the switch is pressed again, the cycle will stop and the current colour will be stored
and remain static (i.e., go back to step 1 in the sequence, with a new stored chosen colour).
DMX Control
Please refer to the purchased DMX Controller for details about how to use it. For 3
rd
party DMX control see section
4.4.
When receiving a DMX signal, the driver LED Indicator will turn on and off approximately once per second. Please see
more info about the Indicator states in the chapter 6.1.
5.2 MAINTENANCE
Marine growth can build up quickly on the light and can reduce the
light’s performance in just a few weeks.
To help prevent this, all OceanLED lights have been coated with a specialized Tritonium® coating which helps to
prevent marine growth from adhering to the glass. Lights should be cleaned with a boat brush or similar bi-weekly, or as
needed to keep the lens of the light clean.
Growth varies greatly around the world and maintenance is imperative to the proper operation and longevity of the
product. If heavy fouling occurs, growth can be removed from the lens using a plastic scraper and moderate pressure
under water. If cleaning the lens while the boat is out of the water, wet the lens before scraping. Never scrape or try to
remove barnacles from a dry lens.
Never use high pressure jet wash to clean the lens / bezel as this will damage the seals and void the warranty.
