EXPLORE
E6 & E7 TH
.
INSTALL & OPERATION MANUAL
9
Installation (Once hull preparation is complete)
1. Test light(s) before fitting.
2. If using a Delrin Isolation Kit, fit the isolation kit tube inside the Isolation kit disc (chamfered sides together) and
apply marine sealant on the back of the disc to seal between the disc/tube and the hull. Insert the part into the
drilled hole in the hull. Press the disc into the hull to spread the sealant around to ensure good adhesion.
3. Apply sealant to the back perimeter of the light body and around flange to ensure a complete unbroken seal
around the light.
Make sure sealant fills in the recess groove on the reverse of the light head.
4. To guarantee correct light orientation ensure the OceanLED logo on the reflector is in the correct orientation
before inserting it in the hull (typically the logo is located at the top). For Explore E7 TH angled fitment, ensure
the light angle is correct for the location before fitting the light. If available, follow the OceanLED Light
Placement Chart (LPC) where the required angle for each light position around the hull will be detailed.
For further details, see the diagram in the Appendix (Section 7.6).