EXPLORE
E6 & E7 TH
.
INSTALL & OPERATION MANUAL
20
OceanLED DMX Control Kits
To use OceanLED DMX Control, one of our DMX kits must be purchased from OceanLED. Please consult the
Explore E6/E7 TH Light Choice Diagram for details (see Chapter 7.3).
To enable the DMX Control of all lights, Explore E6 & E7 Control Link Cables must be used. The quantity of
Control Link Cables required per installation is equal to the number of lights minus 1 (Example: If 10 lights
are used, 9 control link cables are required).
Ensure power is disconnected before attempting to connect or solder any wire.
Please consult the manual for the purchased DMX Control Kit for more information on installation and operation.
3rd Party DMX Control
Additional items required not supplied by OceanLED:
•
External DMX Control System
To use a 3rd Party DMX Control, the Explore Control Input Cable and Terminator Kit is required.
To enable the DMX Control of all lights, Explore Control Link Cables must be used. The quantity of Control
Link Cables required per installation is equal to the number of lights minus 1 (Example: If 10 lights are used,
9 control link cables are required).
Ensure power is disconnected before attempting to connect or solder any wire.
1. Connect the DMX Control unit to the Explore Control Input Cable following the wiring connections below:
Cable colour
Signal
Black
GND
Yellow
DMX +
Brown
DMX -
Red
Not used
2. Plug the Explore Control Input Cable to the
‘Control In’ Connector of the first light.
3. Using the Control Link Cable, connect the
‘Control Out’ of the first light to ‘Control In’ of the next light. Repeat
until all the lights are connected. Check the diagram on the next page for clarification.
4. Plug the Terminator into the
‘Control Out’ of the last light.
External DMX Control Connection Diagram Example
Driver 2
Driver 3
Control Link
Cable
Control Link
Cable
External DMX
Control System
Te
rm
in
at
o
r
Driver 1
C
o
n
tr
o
l O
u
t
C
o
n
tr
o
l I
n
C
o
n
tr
o
l I
n
C
o
n
tr
o
l O
u
t
C
o
n
tr
o
l O
u
t
C
o
n
tr
o
l I
n
