EXPLORE
E6 & E7 TH
.
INSTALL & OPERATION MANUAL
26
6
Troubleshooting
6.1 TROUBLESHOOTING PROBLEMS AND THEIR SOLUTIONS
The Explore TH driver have a built-in LED Indicator that will confirm that the light is working inside the designed
parameters and will give information if a fault has been detected.
The Indicator should be lit when light is powered and on. When receiving a DMX signal, the Indicator will turn on and
off approximately once per second. If light is in Firmware/Bootloader update mode, the LED Indicator will flash rapidly
approximately 3 to 4 times per second.
Should any flashes be observed outside of the time frames mentioned above, please refer to the table below.
The table below summarizes the fault codes the driver LED Indicator can show. The fault code is shown by a repeated
cycle of a succession of flashes followed by an off period.
EXPLORE E6/E7-TH
NO’ OF
FLASHES
DESCRIPTION OF
FAULT
CHECK
CAUSE
FIX
0
Green LED OFF
Check voltage supply to the light is
between 11V and 32V DC
Voltage ok.
Driver is faulty.
Contact your dealer.
1
Driver board
Temperature
Sensor Failure
-
Driver is faulty.
Contact your dealer.
2
LED (light) board
temperature sensor
failure
-
Light is faulty.
Contact your dealer.
3
Power Issue
– large
Voltage drop on
light power-up
detected 10 times
Check wiring gauge. Check if power
source can supply
enough current.
Incorrect wiring.
Inadequate power
source.
Replace wiring with correct
gauge. Replace power source.
4
Power supply
Voltage too low
Check voltage supply to the light is
between 11V and 32V
DC (The light will still work between 10
and
11 volts however at reduced
brightness)
Voltage is too low
Investigate reason for low
voltage and fix
5
Power Supply
Voltage too high
Check voltage supply to the light is
between 11V and 32V DC
Voltage is too high
Investigate reason for high
voltage and fix
If the light
doesn’t recognize the fault but the fault is still present, please check the tables on the following pages.
LED Indicator
