EXPLORE
E6 & E7 TH
.
INSTALL & OPERATION MANUAL
11
6. If using a Delrin Isolation Kit, insert the isolation kit rear washer over the stem and locate it flush with the hull.
7. Insert the stainless-steel compression washer over the stem at the back.
The stainless-steel compression washer does not need to be flat to the hull, the washer can compensate a
slightly uneven surface.
8. Place the two locking latches together to form a circle, ensuring you pair 1 threaded and 1 non-threaded hole
together. Fix the latches together using one of the bolts provided so that the bolt slightly extends from the other
side of the latch. Pre-assemble the bonding attachment parts in the following order: M4 bolt, M4 nut, M4 shakeproof
washer, bonding eyelet. Position the bonding eyelet, nut and shakeproof washer close to the M4 bolt head, while allowing
the bonding eyelet to rotate on the bolt and fit the bolt assembly into the middle thread hole of the locking latch. Fit the
third bolt to the middle threaded hole of the second locking latch and fit the fourth bolt to the remaining hole but do not
join with the second latch yet.
Bonding Eyelet
M4 Shakeproof Washer
M4 Nut
M4 Bolt
Locking Latches
*Installation With Delrin Isolation Kit
