Oce TCS400, User Manual

Page: 64 / 321

64 Océ TCS400 User manual
Create and start a copy job
Introduction
This section describes a general workflow for the copy jobs on the scanner. The
Océ TCS400 scanner can do the following types of copy jobs.
■
Single sheet
■
Set.
Make sure that you define the correct input mode on the scanner operator panel
(see ‘
The copy settings ’).
How to create and start a single sheet job
1
Place the original face down, center aligned along the measurement ruler. If
you feed the original, keep the original in position until it is drawn into the
scanner.
2
On the home screen, select the 'Entry to the copy settings'.
3
Define the job settings on the screen. Use the upper softkeys to select the
setting card and use the lower softkeys to define the settings in the cards.
4
On the 'Input mode' section of the 'Original' card, select 'Single sheet'.
5
On the 'Media' section in the 'Output' card select the required media.
6
Use the numeric keys to define the number of copies.
If the 'Start' key is not pressed before the end of the 'Panel time-out', as defined
in the Océ Settings Editor, all settings return to their default values.
7
Press the green 'Start' key to start the copy job.
Your original is fed into the scanner. The copying starts.
Note:
Make sure you first define the settings before you feed the original.
8
When the original is held at the front side or the back side, use the release
original key on the scanner operator panel to remove the original. (see ‘
The
scanner operator panel ’ on page 32 ).
Note:
Use the KO - Scanner - Settings - Original release mode setting in the
Océ Settings Editor to define the 'Original release mode'. (see ‘Original
release mode’ on page 157).
9
Use the home key to return to the home screen. (see ‘ The scanner operator
panel ’ on page 32 ).