Oce PlotWave 340, Operation Manual, Page: 114 / 336

Access control and IPsec settings
Introduction
When access control is enabled, you can edit the access control settings.
NOTE
Make sure to set a password for changing the security settings. With this password you can
modify the network settings and reset the security settings from the user panel in case you get
locked out of the system. Set the password under the [Configuration] - [Connectivity] tab and
edit the [Password to change network settings]. For more information, please refer to the
connectivity manual.
[Access control] and IPsec settings
Under [Configuration] - [Connectivity] - [Access control], you can set the following settings for
each of the 5 stations:
Setting Description
[Access control sta-
tion 1] Enable or disable communication of this host with the printer.
[Access control sta-
tion 1: IPv4 address] The IPv4 address of the host allowed to connect to the printer.
[Access control sta-
tion 1: IPv6 address] The IPv6 address of the host allowed to connect to the printer.
[IPsec station 1] Enable or disable IPsec. IPsec is a security protocol that encrypts the
communication between the host and the printer.
[IPsec station 1: Pre-
shared key] The key for encryption of this host connected via IPsec. When empty, the
default preshared key is used.
For IPsec. you can set the following setting:
Setting Description
[IPsec default pre-
shared key] This is the default key for encryption of hosts connected via IPsec. This
key holds for all stations whose preshared key is unspecified.
NOTE
For more details on these settings please consult the Océ PlotWave-ColorWave Systems
Security manual.
Access control and IPsec settings
114 Chapter 3 - Define your Workflow with Océ Express WebTools