Océ CS6410 Basic Operation Guide
28
To connect USB cable.
1
USB connector
USB 2.0 cable (B-type connector)
Connect the Printer’s USB 2.0 cable to the USB
connector at the rear center of the Printer.
Important!
- Use the supplied USB 2.0 cable.
- For the USB connection and the related
system, use the USB-compliant hubs and
cables supporting USB 2.0. Note that a normal
operation may not be ensured if the habs,
cables, and the other related devices are not
USB-compliant.
- Use 5m cable or shorter. If the connection
length exceeds 5m, apply hubs to extend the
connection. The hub quantity must be fi ve
or less in total. Note that a normal operation
may not be ensured if a cable exceeding 5m is
applied, or if the cable connection exceeds 5m
without hubs.
2
Clamp the USB 2.0 cable to the Printer along
the wiping unit direction.
To protect the USB connector, clamp the USB 2.0 cable
to the Printer body as shown in the left fi gure.
To extend the cable along the capping unit
direction...
-
As the fi gure below shows, fi x the cable at some
positions with adhesive tape. If the USB cable is not
clamped, the media feed sensor may operate incorrectly.
Summary of Contents for CS6410
Page 98: ......
