Copyright 2010-2017 Obihai Technology, Inc.
52
The default setup of this key provides similar action the
transfer
soft key would, if the highlighted call is in
the Connected or Holding state. After the user dials the transfer target number, where the screen would show
the
xfer.now
soft key, press this key triggers the same action of the
xfer.now
soft key instead.
Two valid alternatives to this behavior is to change
Function
to
Blind Transfer
or
Blind
Transfer 2
when pressing the key would provide corresponding behavior, respectively
4.
Hold
•
Default
Function
=
Hold
The default setup lets the user put on hold all the calls that currently in the connected state by pressing this
key.
5.
Do Not Disturb
•
Default
Function
=
Do Not Disturb
•
Default
Service
=
{
blank
}
The default setup lets user turn on/off Do Not Disturb for the entire phone, locally. One may change the
Service to one of the SP
n
Service instead. And if the selected SP
n
service has the network-provided version of
DND enabled, this key controls the on/off of the netowork-provided version (instead of the version provided
by the phone locally). The default configuration sets the LED to solid red when the underlying DND setting is
ON, or off otherwise
6.
Call Forward
•
Default
Function
=
Call Forward
•
Default
Service
=
{
blank
}
The default setup lets user turn on/off Call Forward Unconditional (a.k.a. Call Forward All or Call Forward
Always) for the entire phone, locally. One may change the Service to one of the SP
n
Service instead. And if the
selected SP
n
service has the network-provided version of Call Forward Always enabled, this key controls the
on/off of the netowork-provided version (instead of the version provided by the phone locally). The default
configuration sets the LED to solid red when the underlying Call Forward Always setting is ON, or off
otherwise.
7.
Voicemail
•
Default
Function
=
Message Status
You should set up the
Number
and
Service
parameters of this key to access voicemail.
8.
Next Tab
•
Default
Function
=
Next Tab
The default setup provides the function of changing the (right) line key tab. We do not recommend changing
the function of this key.