Nxg NX-RM505, Operating Manual

Page: 30 / 80

6. Programming Macro Buttons
In this case we are going to use the M1 button to turn on the TV,
the receiver, the Cable box, choose the appropriate inputs and tune
in the channel where we normally watch the morning news.
1 Press MAIN and ENTER simultaneously for three seconds.
2 Press MACRO .
3 Press M1 .
4 Press AUDIO. (Takes you to the Audio device page.)
5 Press POWER. (The button on the top right of the remote.)
6 Press TV. (This takes you to the TV device page.)
7 Press POWER.
8 Press MAIN.
9 Press CABLE. (This takes you to the Cable device page.)
10 Press POWER.
11 Press MAIN .
12 Press AUDIO. (We are returning to this page because most
receivers and amps take time to ‘cycle up’ and can't receive any
commands, such as input, until the device is ready. So we have had
the other steps of the macro running while the Audio device is
‘cycling up’.)
13 Press PAUSE three times. (The button on the bottom right of the
joystick. We’ve done this since our particular receiver takes longer
than normal to ‘cycle up’, so we have pressed the PAUSE button to
insert more time for the receiver to get to the point where it will
receive another command. Pressing the PAUSE button three times
allows for an extra. 6 seconds of wait time. 3 x .2 seconds per
push = .6 seconds)
14 Press CATV. (Since you are in the Audio device, this selects the
‘CableTV’ input on that device.)
NX-RM505
30
NX-RM505_Remote_Manual 10/6/08 6:17 PM Page 30