Nussbaum COMBI LIFT 4.80 H, Operating Manual And Inspection Book

Page: 36 / 63

Operating Manual and Inspection Book
COMBI LIFT 4.80 H / HYMAX II 8000
36 Version 3.0
The entire contact area of each wheel must be completely on the drive-in rails,
otherwise there is a danger of falling!
5.3 Platform illumination (optional)
There are four lamps integrated on the interior side of the drive rails to give equal illumina-
tion of the work area.
The illumination is switched on via the main switch (11) of the platform.
5.4 Lifting the vehicle
During the entire lifting or lowering process, the work area of the lift should be clear of
people and objects.
Afterwards, lift the vehicle to the desired working height.
Absolutely ensure secure vehicle placement on the drive-in rails, otherwise
there is a danger of the vehicle falling.
Switch on controls at the main switch (a).
Lift the vehicle. Push the
↑ “LIFT” button (b).
Raise the vehicle to the desired working height.
The entire lifting process must be continuously observed.
5.5 Set down into the safety ratchets
• Pushing the “Lower into catches” button (d) sets the lift down into the next possible
catches.
• Keep the “Lower into catches” button (d) until all four safety ratchets are latched in and
the lift can no longer move downwards.
Before working on the vehicle always lower the lift into the safety ratchets.
5.6 Lift out of the safety ratchets
Check the hazardous area around the platform and ensure that there are no
people or objects in the immediate vicinity of, or on, the platform.
Push the
↑ “LIFT” (b) button until the catches are released.