Nussbaum COMBI LIFT 4.80 H, Operating Manual And Inspection Book

Page: 49 / 63

Operating Manual and Inspection Book
COMBI LIFT 4.80 H / HYMAX II 8000
49 Version 3.0
9.3 Change of lift location
If the place of installation is to be changed, the new place has to be prepared in ac-
cording to the regulations of the first installation. The change should be performed in
accordance with the following points:
• Remove the spring at the ratchet-strip.
• Lower the lift in the lowest position
• Loosen and remove the ratchet-strip. If necessary, pull back the ratchet manually.
• Remove the cover of the Oil tank and remove the oil.
• Raise the lift on a working height. Press the button „lifting“
• Lower the lift until the rails are lay on the erection trestles.
• Disconnect the power supply.
• Disconnect the hydraulic hoses.
• Loosen and remove the dowels.
• Loosen and remove the screws of the crossbeam.
• Transport the automotive-lift to the its new location
• Install the lift in accordance with chapter 9 “ Installation and Initiation”.
Use new masonry-bolts, the used bolts can not be used again.
A security check must be performed before reinitiating by a competent
person. Use form “Regular security check”
9.4 Initiation
Before the initiation a security check must be carried out. Therefore use
the form: First security check.
If the lift is installed by a competent person, he or she is to perform the security
check. If the operator installs the lift by him or herself, he or she must instruct a
competent person to perform the security check.
The competent confirms the faultless function of the lift in the installation record and
the form for the security check and authorises the use of the lift.
Please send the completed installation record to the manufacturer after
installation.