Nussbaum COMBI LIFT 4.80 H, Operating Manual And Inspection Book

Page: 34 / 63

Operating Manual and Inspection Book
COMBI LIFT 4.80 H / HYMAX II 8000
34 Version 3.0
4 Safety regulations
If you use the automotive lift, the German following regulations are to be considered:
BGG945: Examine of automotive-lifts; BGR500 Using automotive-lifts; (VBG14).
Especially the following regulations are very important:
• The laden weight of the lifted vehicle must not exceed 8000 kg for the automotive lift.
Load distribution max. 2:1 in or against the drive on direction.
• The automotive lift must be in its lowest position (fully collapsed), before the vehicle
can be driving on to the lift. Only then can the vehicle be lifted.
• While working with the lift the operating instructions must be followed.
• Vehicles with low clearance or vehicles that are specially equipped should be pre test-
ed to ensure that they clear the lift ramp to avoid damage.
• Only trained personnel over the age of 18 years old are to operate this lift.
• No one is to stand within the working area (danger area) during lifting and lowering
• No one is to be raised or lowed either directly or in a vehicle by the automotive lift.
• No one is to climb onto the automotive lift or onto an already raised vehicle.
• The automotive column lift must be checked by an expert after changes in the con-
struction have been made.
• The main switch must be switched off and locked before work on the vehicle can com-
mence. This is a safety precaution to ensure that the lift does not move during work.
• The main switch must be switched off and locked before any maintenance or repair
work on the automotive lift itself can be carried out.
• During lifting or lowering the operator must observe the vehicle to ensure that the ve-
hicle and the lift are functioning correctly.
• Installation of the standard-mobile column lift in hazardous or dangerous locations such
as washing bays is dangerous and is not allowed.