15
FIBER_TIGER_manual, 2021-11-29
4. Preparing for use
4.3. Installing
4.3. Installing
This section summarizes procedures necessary to mount the scan head in the laser unit
and to connect all supply lines.
4.3.1. Incorporating the scan head into a superordinate machine
Target audience and qualification
Experts
Have ready
Choose which mounting threads you want to use either at the front (4
×
M8) or
bottom (4
×
M5) side and then the respective screws; see figure 4.1 on page 16.
Head shape and length are depending on the design of your counterpart
Suitable screwdriver
Requirements
Table 4.2.: Environmental conditions for installation and operation
Characteristic
Specification
Environment
Operate the scan head only indoors in a dry and clean en-
vironment without conductive contamination.
Degree of protection
by enclosure
IP54; when using purge gas
Temperature
10 to 40 °C (283 to 313 K)
Humidity
max. 80 %; non-condensing
Altitude
max. 2,000 m
Acceleration
max. 2.5 g
