MicroE Optira Installation Manual
Celera Motion
IM-1001 | REV181211
Page 7
©2018 Celera Motion
4.3 Optional Development Kit
The following are the components of the optional Development Kit model PI-DK:
Part
Description
Connector and
Calibration Board
Interface board located between the Optira sensor and the customer’s controller:
•
Provides feedback of sensor operation to customer electronics
•
Provides control for calibration and alignment
•
Size: 0.591" x 0.886"
•
No signal processing
200mm FFC Cable
Flat flexible cable (FFC) that connects sensor to optional interface board or
directly to customer electronics:
•
Digikey 732-3556-ND
•
Wurth Electronics
®
part number 687610200002 (0.5 mm, Type 1, 10P,
200 mm)
3m Controller Cable
Custom Development Kit Cable with JST
®
Connector and 15-Pin D-Sub to
connect between Connector and Calibration Board and customer’s electronics.
Z-Height Shim Spacer
Shim for setting gap between sensor riser and top of installed scale.
4.4 Optional Connector and Calibration Board
This section contains information needed to install the optional Connector and Calibration Board.
LED Configuration Switch S2
Switch
Description
On
Off
1
Red Alarm LED (D2)
Alarm is active low
Alarm is active high
2
Green Power On LED (D1)
1
Power On LED is On
Power On LED is Off
Default from factory: both S1 and S2 are set to ON.
Note
1
:
S2 is not a power switch; intended only to turn LED off for light sensitive applications.
LED Configuration Switch (S2)
Calibration
Pushbutton (S1)
Green Power On
LED (D1)
Red Alarm
LED (D2)
Connector J2
Connector J1
J1 Pin 1
Note
: Protect the
mounting area with
insulating material.
(Mounting Holes)
