Notifier CFP-600-E, Installation And Operating Manual

Page: 7 / 33

ENTERING PASSWORDS
To perform the functions available on the control panel, it needs to enter a specific Password, made up of 1 to 4 figures,
depending on the programmings carried out. Factory default passwords are:
•
Level 1 = 1
•
Level 2 = 2
•
Level 3 = 3
•
Level 4 = 4
Use CURSOR keys to enter passwords. By pressing them, the display will show a
figure which can be increased or decreased always by pressing CURSOR keys.
After choosing each figure, press ENTER. If the password is accomplished , press
ENTER key again, otherwise choose next figure, always by using CURSOR keys,
followed by ENTER .
Level 1 Password can be modified from any other higher level (2 to 4).
USER MENU - LEVEL - 1 -
To have access to User Functions, press ENTER , and the display will show:
Press UPWARDS CURSOR Key.
Level Password will be required. Enter the relevant programmed password.
The display will show the first available function in USER mode:
Use CURSOR KEYS to display the desired function, choosing among:
•
Enable Release Channels
•
Display ZONE status
•
Change Zones - Enable/Disable Status
•
Change Day-Night mode
•
Display Historical Log
•
Change Prealarm Recognition Time (Level 3 Password required)
•
Alarm counter
•
Change Date/Time (Level 3 Password required)
•
Change Level 1 Password
Press ENTER to confirm the selection.
ENABLE RELEASE CHANNELS
This function allows to enable or disable the two release channels.
If one channel is disabled and the release board is programmed as installed (See Configuration Menu), the release inhibi-
tion yellow LED of the relevant channel will blink.
Press ENTER key
Use CURSOR keys to select the release channel
Press ENTER to change the release channel programming.
CFP-600-Prog-1.VP Installation and Operating Manual Page 3
Doc. M-131.1-CFP600-ENG Rev. B.1 NOTIFIER ITALIA
:User Mode | A08
:Test Mode | G08
:Configuration | D00
:Exit | E00
USER MODE |A08
ZONES STATUS |G02
|D00
|E00
LEV.1 PASSW. | A08
__ | G02
| D00
| E00
LEV.1 PASSW. | A08
__ | G02
| D00
| E00
LEV.1 PASSW. | A08
* * __ | G02
| D00
| E00
ENA.REL.CHAN.|A00
N 1 |G00
N 0 |D00
|E00
USER MODE |A00
ENA.REL.CHAN.|G00
|D00
|E00
ENA.REL.CHAN.|A00
N 1 |G00
N 0 |D00
Modify Exit|E00
NOTE : If at Level 4 of Configuration Menu, the release board enabling
(Enabling Function Menu), has not been programmed, it is not possible to
modify the release channel enabling.
At the power ON of the control panel the release channels are disabled.