CHANGE CONTROLS - ENABLE/DISABLE STATUS
This function allows to disable the following controls:
•
General Relays (Trouble, Pre-Alarm, Alarm, Sounders)
•
External Relays (All controls of 16-relay Board)
•
Release (Both the Release Board channels)
Use CURSOR Keys to select one of the following controls:
•
General relays
•
External relays
•
Release
Then press ENTER to modify the programming status of the control se-
lected.
The control panel will display the screen as in the example.
Press ENTER to Enable or Disable.
Press ESC to go back to the main screen.
By programming the panel with disabled controls, the Zone Test LED will switch ON.
»
NOTE: by disabling a control, it will never activate.
SELECT ZONE FOR WALK-TEST MODE
This function let you manually test detector alarms.
Press ENTER to have access to Walk-Test function.
During the test, the screen will show:
If during the Walk-Test a sensor alarm is detected the control panel, after a programmable time-out (see Configuration
Menu) will carry out zone reset. The operator who has simulated a detector alarm, will see the sensor LED to turn-off, and
he will be able to test the next detector.
During the Walk-Test the Zone Test LED will flash.
In order to accomplish manually the Walk-Test, the operator has to go into WALK TEST menu and clear the number of the
zone under test.
DISPLAY FIRMWARE REVISION
By pressing ENTER, it is possible to display the Software Revision Number installed on the control panel.
Will you please always quote this number for your assistance requests.
Press ESC to go back to the main screen.
Page 8
Installation and Operating Manual
CFP-600-Prog-2.VP
NOTIFIER ITALIA
Rev. B.1
Doc. M-131.1-CFP600-ENG
DIS. CONTROLS | A08
GENER. RELAYS | G08
NO
| D00
| E00
DIS. CONTROLS | A08
GENER. RELAYS | G08
NO
| D00
Modify
Exit | E00
WALK TEST
| A08
ZONE
| G08
0
| D00
| E00
Press ENTER
WALK TEST
| A08
ZONE
| G08
0
01
| D00
| E00
Use CURSOR keys to
Select the zone to be tested
TEST MODE
| A08
WALK ZONE
| G08
Z.01 A:000
| D00
| E00
Zone nr. in Walk Test
Total alarms detected during the Test
WALK TEST
| A08
ZONE
| G08
1
| D00
| E00
Press ENTER
Use CURSOR keys to
select 00
TEST MODE
| A08
FIRMWARE REVIS.| G08
| D00
| E00
FIRMWARE REVIS.| A08
| G08
CFP-600/170397 | D00
| E00
WALK TEST
| A08
ZONE
| G08
1
00
| D00
| E00
