GLOSSARY
q
WATCH-DOG
: bright signal and circuit which surveys the microprocessor correct operating.
q
ZONE ENABLED
: zone which detects alarms and troubles.
q
ZONE DISABLED
: zone which detects only troubles (line cut and short circuit).
q
ZONE EXCLUDED
: zone which does not detect either alarms or troubles.
q
CONTROL PANEL IN “DAY MODE
”: operating mode which allows the operator to inspect the event on
field, before signal silence or reset. See flow chart in Appendix A.
q
CONTROL PANEL IN “NIGHT MODE”
: automatic operating mode. See flow chart in Appendix A.
q
CONTROL PANEL POWER ON
: signal which latches the control panel power ON.
q
RECOGNITION TIME
: time which allows the operator to carry out a system recognition in alarm condition
(only with the control panel in “Day Mode”), before alarm and siren output activation.
q
WALK TEST
: zone manual test which allows to performe a manual detector test.
q
VERIFICATION TIME
: this function allows to prevent false alarms from a zone. When detecting a zone
alarm with programmed verification time the system performes an automatic zone reset; if detecting an
alarm coming from the same zone, before the verification time end, the panel activates the alarm sequence.
q
PREALARM OUTPUT ACTIVATION TIME
: it is the time during which the prealarm relay remains active in
zone prealarm condition.
q
ALARM OUTPUT ACTIVATION TIME
: it is the time during which the alarm relay remains active in zone
alarm condiiton.
q
SIREN OUTPUT ACTIVATION TIME
: it is the time during which the siren relay remains active in zone
alarm condition.
q
PREALARM OUTPUT STAND-BY TIME
: it is the time during which the prealarm relay remains in OFF po-
sition even in presence of a new zone prealarm. This timing starts when the prealarm output activation time
ends.
q
ALARM OUTPUT STAND-BY TIME
: it is the time during which the alarm relay remains in OFF position
even in presence of a new zone alarm. This timing starts when the alarm output activation time ends.
q
SIREN OUTPUT STAND-BY TIME
: it is the time during which the siren relay remains in OFF position even
in presence of a new zone alarm. This timing starts when the siren output activation time ends.
q
MEMORY VERIFICATION
: integrity test of the EEPROM memory (all the user programmings are stored in
the EEPROM memory).
q
SIGNAL SILENCE
: manual operation which allows in case of zone alarm to silence the buzzer and the si-
lenceable alarm outputs, leaving the event on the LCD display.
By pressing again this front panel key the previous cleared outputs reactivate.
q
RESET
: manual operation which allows in case of zone alarm to silence the buzzer and the not silenceable
alarm outputs as well as allows to clear the alarms on the display.
Page 27
Installation and Operating Manual
CFP-600-Gloss-E.VP
NOTIFIER ITALIA
Rev. B.1
Doc. M.131.1-CFP600-ENG
