Maintenance Instructions
75
4.3.1.2 Clutch Fingers Adjustment
When the previous adjusement does not meet the requirements of
35–40 mm. of clutch pedal free travel, it means that the throwout bearing
has moved backward and is sitting tight on the carrier. The following
adjustment inside the clutch should be carried out:
1.
Remove the inspection plate for the clutch on the transmission.
Figure 4-2 Inspection Plate Removal
2.
Loosen the nut and adjust the screw for the clutch fingers with a wrench.
3.
Make the clearance between the three clutch fingers on top of the clutch cover and the throwout bearing
2–2.5 mm. The three clutch fingers of the clutch cover should be on the same plane .
Their position tolerance should be less than 0.2 mm.
4.
Tighten the lock nut after adjustment.
5.
Check the clultch pedal free play to ensure that the stroke is within
the range of 35–40 mm.
6.
Reinstall the inspection plate on the transmission.
Figure 4-3. Release Rod Adjustment
4.3.1.3 Main Clutch Release Travel Adjustment
1.
There should be suitable pedal travel from the main clutch release to the auxiliary clutch release, to avoid
the auxiliary clutch releasing too early.
2.
To obtain a suitable path, the clearance between the three adjusting
screws (2) on the main pressure plate of the clutch and the three
fingers (1) of the auxiliary friction discs pressure plate should be
1.7mm. Turn the adjusting screw and insert a feeler gauge to adjust the
clearance between the bolt head and the finger of the auxiliary friction
pressure plate so that it is 1.7 mm.
Figure 4-4
3.
The lock nut should be tightened after adjustment. Main Clutch Release Travel Adjustment
1. Lug 2. Set Screw 3. Lock nut
Summary of Contents for 82XTC
Page 53: ...Electrical Schematic 47...
Page 117: ...TD80 Serials TD824 1F461D19K...
