Operation Instruction
24
Figure 2-26 Tractor Start
2.5 Running the Engine
1.
After the engine is started, ease up on the throttle immediately to allow the engine run at idle. Check the
engine oil pressure to ensure that the indicator on the oil pressure gauge is in the green zone.
2.
After the engine is started, do not run a full-load immediately. The engine should be run at idle to medium
speed to heat the engine. When the coolant temperature rises above 140
F, you can then increase to high
speed and operate at full load capacity.
3.
The engine rpm and load should be slowly increased or decreased, especially for a recently started engine.
Never use the hand throttle to run at high speed.
4.
When the tractor is running the engine oil pressure and coolant temperature should be checked regularly.
During normal operations of the engine, the indicator on the oil pressure gauge and water thermometer
should be in the green zone.
5.
When running the engine, the oil pressure and coolant temperature should be checked regularly. During the
normal operations of the engine, the cooling temperature should be around 85°C (185
F) and the engine oil
pressure should be 310 to 345kPa. (45-50 psi).
IMPORTANT ISSUES:
In order to avoid damage to the engine, never let the oil pressure fall below 9kPa (1.31psi). If the oil pressure is
dangerously low, shut down the engine and troubleshoot the problem immediately.
2.6 Putting the Tractor in Motion
1.
Set the shuttle gear shift to Forward or Reverse.
2.
Set the range gear shift into the Low range.
3.
With the engine running at low speed, step on the
clutch pedal. Then, put the gear shift level in the
desired speed. To prevent gear tooth breakage in the
transmission or early clutch damage, do not start the
engine in the High gear range.
4.
Release the parking brake.
5.
Gradually increase the engine speed and slowly release the clutch pedal until the clutch engages, then fully
release the clutch to get the tractor running properly. Gradually accelerate to the required operating speed.
Summary of Contents for 82XTC
Page 53: ...Electrical Schematic 47...
Page 117: ...TD80 Serials TD824 1F461D19K...
