Maintenance Instructions
72
4.1.5 Technical Maintenance for Every 1000 Work Hours
1.
Perform all technical maintenance required for every 500 work hours.
2.
Change the hydraulic system oil.
3.
Flush cooling system and radiator. Refill with a 50/50 water/anti-freeze mixture.
4.
Clean the transmission case and change the oil in the transmission when the tractor is warm.
5.
Clean the oil filter in the hydraulic system, and check the cleanliness of the hydraulic oil.
When necessary, drain the sump of the lifter case, clean it with solvent, and change the oil.
6.
Check and adjust the fuel injection pressure of the diesel fuel injection pump.
7.
Drain and flush the fuel tank and clean the filter in the fuel tank.
8.
Inspect the hydraulic suspension mechanism and do maintenance if necessary, according to the
work situation.
9.
Carry out maintenance of the engine according to the level 4 maintenance requirements in the
engine manual.
4.1.6 Technical Maintenance for Every 1600 Work Hours
1.
Perform all technical maintenance required for every 1000 work hours.
2.
Check engine to manufacturer’s specifications.
3.
Change the lube oil in the front drive axle central drive the final drive.
4.
Check for bearing noise in the clutch and front end.
5.
Check whether the clearance and contact points of the central transmission gears are normal.
Check the clearance and pre-loading condition of bearings, and adjust if necessary.
6.
After completing the maintenance, assemble the whole machine and carry out a short-term trial run.
Check and adjust each mechanism as necessary.
7.
Maintain the diesel engine according to the requirement of level 3 technical maintenance described in
diesel engine operation and maintenance manual.
4.1.7 Special Technical Maintenance (Winter)
When the temperature is below freezing, along with the "Technical Maintenance per Shift", the following
provisions should be strictly observed:
1.
Select winter grade fuel and lubricating oil.
2.
Check the strength of the coolant with a hygrometer. If necessary add anti-freeze to the cooling system as
Summary of Contents for 82XTC
Page 53: ...Electrical Schematic 47...
Page 117: ...TD80 Serials TD824 1F461D19K...
