REPLACING WORN CONSUMABLE PARTS for PUSH-PULL TORCH
May 25, 2022
Page 32
User Manual No: OM-10
4
A EN
7.05
PUSH-PULL: Changing Torch Cable Liner
a) Disconnect power to MIG/MAG equipment.
b) Lay the Torch cable out straight.
c)
Liner Nut (2)
–
Remove use an appropriate wrench in
a counter clockwise direction.
d)
Liner (3)
–
Remove by pulling the liner end out of the
Euro Power Pin Connector Block
.
e) With the Torch laying straight, insert new liner into
Euro Power Pin Connector Block and feed 50mm at a
time into the Torch using a twisting motion to stop the
liner from kinking.
f)
Secure Liner (3)
–
Screw
Liner Nut
(2)
into Pin Con-
nector Block to secure the Liner.
g)
New Liner Trim Length
–
Trim liner close to Back In-
let Guide of the PUSH-PULL Torch if needed. Remove
all burrs from end of liner.
