North KLASIK Series, Operating Manual

Page: 20 / 40

SPOOL TORCH: Wear Parts & Torch Parts
May 25, 2022 Page 20 User Manual No: OM-10
4
A EN
5.04 SPOOL TORCH QLBF-185: Change Pressure Roll / Drive Roll
CHANGE Drive Roll (8)
a) Disconnect Power to the MIG/MAG equipment.
b) Unscrew Handle Nut (1) , and 3 x Handle Screws (2) .
c) Wiggle the Handle Half (3) away from the Spool Torch.
d) Unscrew and remove Screw (4) and Washer (5) from the Drive Shaft.
e) Push down on the red Pressure Roll Release Button (10) then slide the
Drive Roll (8) off the Drive Shaft. Do NOT lose the Drive Key (9) .
f) Fit a new Drive Roll (8) and then re-assemble the Spool Torch.
Note : Ensure the Drive Key (9) is fitted into the slot of the Drive Shaft
then line up the slot in the Drive Roll (8) with the Drive Key (9) .
CHANGE Pressure Roll (6)
a) Disconnect Power to the MIG/MAG equipment.
b) Unscrew Handle Nut (1) , and 3 x Handle Screws (2) .
c) Wiggle the Handle Half (3) away from the Spool Torch.
d) Push down on the red Pressure Roll Release Button (10) then unscrew
the Screw (4) to remove the Washer (5), Pressure Roll (6), and Bear-
ing (7) from the Pressure Mechanism. Do NOT lose the Bearing (7) .
e) Fit a new Pressure Roll (6) and then re-assemble the Spool Torch.
5.05 SPOOL TORCH QTLB-24D / QTLB-36D: Change Pressure Roll / Drive Roll
CHANGE Drive Roll (8)
a) Disconnect Power to the MIG/MAG equipment.
b) Unscrew Handle Nut (1) , and 3 x Handle Screws (2) .
c) Wiggle the Handle Half (3) away from the Spool Torch.
d) Unscrew and remove Screw (4) and Washer (5) from the Drive Shaft.
e) Push down on the red Pressure Roll Release Button (10) then slide the
Drive Roll (8) off the Drive Shaft. Do NOT lose the Drive Key (9) .
f) Fit a new Drive Roll (8) and then re-assemble the Spool Torch.
Note : Ensure the Drive Key (9) is fitted into the slot of the Drive Shaft
then line up the slot in the Drive Roll (8) with the Drive Key (9) .
CHANGE Pressure Roll (6)
a) Disconnect Power to the MIG/MAG equipment.
b) Unscrew Handle Nut (1) , and 3 x Handle Screws (2) .
c) Wiggle the Handle Half (3) away from the Spool Torch.
d) Push down on the red Pressure Roll Release Button (10) then unscrew
the Screw (4) to remove the Washer (5), Pressure Roll (6), and Bear-
ing (7) from the Pressure Mechanism. Do NOT lose the Bearing (7) .
e) Fit a new Pressure Roll (6) and then re-assemble the Spool Torch.
(2)
(3)
(4)
(5)
(8)
(9)
(10)
(1)
Drive Shaft
(2)
(3)
(4)
(5)
(6)
(10)
(1)
(7)
Pressure
Mechanism