PUSH-PULL TORCH: Wear Parts & Torch Parts
May 25, 2022
Page 28
User Manual No: OM-10
4
A EN
SECTION 7
–
PUSH-PULL TORCH: Wear Parts & Torch Parts
Torch installation must be
done by a suitably Trained
and Qualified Tradesperson.
Disconnect power to
MIG/MAG equipment. Elec-
tric shock can kill.
Flying metal or
dirt can injure
eyes.
FUMES and Shielding GAS can
be hazardous to your health.
Moving parts
can cause injury.
Welding wire
can cause in-
jury
Improper instal-
lation can cause
fire.
Read User
Manual.
Genuine JINAN NORTH WELDING TOOLS parts must be used for safety and performance reasons, or the warranty becomes invalid.
In-
spect all parts for transportation damage.
Do not use damaged or worn parts.
Before starting the MIG/MAG equipment, check the whole
installation according to the manufacturer's instructions, this Manual and applicable national / state / local safety regulations.
7.01
PUSH-PULL: Change Wear Parts for QTLB-24D, QTLB-36D, PG4000 / PG4045, PW5000 /
PW5045
a) Disconnect power to MIG/MAG equipment.
b)
Remove
---
Nozzle (1):
Remove the slide
–
on nozzle by using a twisting pull ac-
tion.
---
Contact Tip (2):
Cut
Welding Wire
(electrode) close to the
Contact
Tip (2)
and remove burrs before turning the
Contact Tip (2)
in a
counter clockwise direction.
---
Tip Holder (3):
Remove using an appropriate tool.
---
Gas Diffuser (4):
Remove using an appropriate tool.
---
Swan Neck Liner (5):
Pull the
Swan Neck Liner (5)
by using an ap-
propriate tool using a twisting out of the
Swan Neck
.
c)
Replace
---
Swan Neck Liner (5):
Fit the
Swan Neck Liner (5)
in to the
Swan
Neck
.
---
Gas Diffuser (4):
Fit using an appropriate tool.
---
Tip Holder (3):
Fit using an appropriate tool.
---
Contact Tip (2):
Fit the contact tip turning the
Contact Tip (2)
in a
clockwise direction.
d)
Nozzle (1):
Fit the nozzle by using a twisting push action.
a) Disconnect power to MIG/MAG equipment.
b)
Remove
---
Nozzle (1):
Remove the slide
–
on nozzle by using a twisting pull ac-
tion.
---
Contact Tip (2):
Cut
Welding Wire
(electrode) close to the
Contact
Tip (2)
and remove burrs before turning the
Contact Tip (2)
in a
counter clockwise direction.
---
Tip Holder (3):
Remove using an appropriate tool.
---
Swan Neck Liner (5):
Pull the
Swan Neck Liner (5)
by using an ap-
propriate tool using a twisting out of the
Swan Neck
.
c)
Replace
---
Swan Neck Liner (5):
Fit the
Swan Neck Liner (5)
in to the
Swan
Neck
.
---
Tip Holder (3):
Fit using an appropriate tool.
---
Contact Tip (2):
Fit the contact tip turning the
Contact Tip (2)
in a
clockwise direction.
d)
Nozzle (1):
Fit the nozzle by using a twisting push action.
Disconnect
