North KLASIK Series, Operating Manual

Page: 25 / 40

PUSH-PULL TORCH: Installation and Operation
May 25, 2022 Page 25 User Manual No: OM-10
4
A EN
SECTION 6 –
PUSH-PULL TORCH: Installation and Operation
6.01 PUSH-PULL: Environmental Limits
Air-Cooled, and Water-Cooled MIG/MAG Manual Welding
Torches are
designed for use in environments where:
• Operating temperature range is -10 °C to +40 °C
(+14 °F to +104 °F)
•
Relative air humidity during operating is 0% to 90% @
+ 20 °C ambient air temperature
6.02 PUSH-PULL: Operation Guidelines
Be sure to locate the MIG/MAG equipment according to
the following guidelines:
• In areas, free from moisture and dust.
•
In areas, free from oil, steam, and corrosive gases.
• In areas, not subjected to abnormal vibration or shock.
•
In areas, not exposed to direct sunlight or rain.
Torch installation must be
done by a suitably Trained
and Qualified Tradesperson.
Disconnect Power to
MIG/MAG equipment. Elec-
tric shock can kill.
Flying metal or
dirt can injure
eyes.
FUMES and Shielding
GAS can be hazardous
to your health.
Moving parts
can cause in-
jury.
Sparks, weld spatter or
hot work piece can
cause fires and burns.
Improper instal-
lation can cause
fire.
Read User
Manual.
Genuine JINAN NORTH WELDING TOOLS parts must be used for safety and performance reasons, or the warranty becomes
invalid.
Inspect all parts for transportation damage. Do not use damaged parts.
6.03 PUSH-PULL TORCH: Connecting Torches Euro Power Pin to MIG Equipment Adaptor
For Push-Pull Torches QTLB-24D-6, QTLB-24D-8, QTLB-36D-8, QTLB-36D-6, PG4000-6, PG4045-6, PG4000-8, PG4045-8,
PW5000-6, PW5045-6, PW5000-8, and PW5045-8.
Euro Power Pin Connector Block to Euro Style Adaptor
a) Disconnect Power to the MIG/MAG equipment.
b) Align Euro Power Pin Connector Block with Euro Torch Adaptor then in-
sert it.
c) Secure tighten the Connector Nut into the Euro Adaptor .
d) Connect the Multi-Pin Plug to the MIG/MAG equipment Control Socket.
e) With PW5000, and PW5045 Water-Cooled torches (Not Shown) connect
the:
---
Red Connection hose fitting to the Red Connector on the MIG/MAG
equipment.
---
Blue Connection hose fitting to the Blue Connector on the MIG/MAG
equipment.
Disconnect