Nortel ISDN Signaling Link, Description, Installation And Operation

Page: 364 / 380

Page 364 of 378 Appendix D: Configure a Netgear RM356 modem router for remote access
553-3001-202 Standard 1.00 April 2000
16 Under "Telco Options" toggle
"CLIDAuthen=None/Preferred/Required".
CLID requires a C.O. line subscribed for CLID service where available.
"Preferred" means some dial-in user profiles may require CLID, but
others may not. "Required" means no dial-in call is connected unless
CLID is provided and user profiles require CLID for authentication.
Under "PPP Options" toggle "Recv Authen=PAP". Windows 9x Dialup
Networking (DUN) is not compatible with CHAP/PAP or CHAP on the
modem router: calls are disconnected after a few minutes.
Toggle "Compression=No". Windows 9x DUN is not compatible with
software compression on the modem router: calls are randomly
disconnected.
Toggle "Mutual Authen=No".
Under "IP Address Supplied By:" Toggle "Dial-in User=No", "IP
Pool=Yes". For "IP Start Addr=" type in the E-LAN IP address that will
be assigned to the Dialup Networking (DUN) PPP client on the remote
MAT PC.
Note: The remote MAT PC will receive this E-LAN IP address
whenever DUN makes a dial-in PPP connection to the modem router.
As long as DUN remains connected to the modem router, IP
applications on the remote MAT PC function as if the PC were located
on the customer's E-LAN.
Under "Session Options" configure input and output filter sets
according to the customer's IP network security policy and practices.
The default setting is no filter sets. Set "Idle Timeout=1200" seconds
to provide 20 minutes idle timeout disconnect for remote support
purposes.
Press Enter to confirm and save data to ROM.
17 Enter menu selection number 14, "Dial-in User Setup", under the
"Advanced Applications" section.
"Menu 14 - Dial-in User Setup " is displayed.
Note: Up to eight dial-in user profiles may be defined according to the
customer's network security policy.
18 Enter menu selection 1 to edit the first dial-in user profile.
"Menu 14.1 - Edit Dial-in User" is displayed.