Nortel BCM50, Installation And Maintenance Manual

Page: 85 / 246

Chapter 7 Installing the main unit 85
BCM50 Installation and Maintenance Guide
Figure 32 Wallmount bracket
4
Install one #8 x 2 cm (#8 x 0.75 in.) round-head wood screw in the backboard.
Do not tighten the screw head against the backboard. Leave approximately 0.5 cm (0.25 in.) of
the screw exposed from the backboard.
5 Prepare the wallmount bracket by removing the alignment tabs:
• If this is the only unit in the BCM50 system, remove the alignment tabs on the right side of
the wallmount bracket.
• If this is the last unit on a BCM50 system with multiple units, remove the alignment tabs
on the left side of the wallmount bracket.
If these options do not meet your requirements, other options that are more difficult to connect
are available. For example, you can route the Amphenol connector cable to the left of the unit,
or you can route the cable straight down the wall.
6
Hang the wallmount bracket on the mounting screw.
7 Use a level to make sure the wallmount bracket is level.
8
Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the
wallmount bracket (see
Figure 32 ).
9
Tighten the three wood screws against the wallmount bracket.
10 Open the cable management door.
11
Install two #8 x 2 cm (#8 x 0.75 in.) round-head wood screws into the screw holes in the cable
trough.
1
1
1
2
2
2
Note
: When using three screws,
Nortel recommends installing the
screws in the three holes labeled
“1” or the three holes labeled “2”.