Nordson Spectrum VT Feed Center, Product Manual

Page: 80 / 105

Repair
7-16
Part 1611362 − 01
E 2018 Nordson Corporation
Blanking Plate Installation
See Figure 7-18.
NOTE: Clean the blanking plate (2) with isopropyl alcohol before applying
the gasket (1). The gasket alignment is not symmetrical.
1. Insert the bushing (5) into the pump port.
2. Align the appropriate blanking plate (2) with the ports on the pump
manifold.
NOTE: There is a 1-pump and a 2-pump blanking plate depending on
the configuration of the assembly.
3. Insert the 65-mm button head cap screw (4) through the top of the
blanking plate.
4. From the bottom side of the pump manifold, the washer (6) slides onto
the 65-mm button head cap screw (4) and then the nut (7).
5. Using a 5-mm Allen wrench, insert the 25-mm button head cap screw
(3) into the threaded pump port.
NOTE: The manifold seal (8), Nordson part 1608597, comes pre-installed.
If there is a need to replace the seal, apply adhesive to a syringe or Q-tip
and securely set the seal in the manifold port.
2
1
5
6
7
4
3
4
6
7
8
Installing Blanking Plate Siphon Block Pump Manifold Section View
Figure 7-18 Blanking Plate Installation