Nordson Encore LT Automatic, Customer Product Manual

Page: 35 / 71

Operation
4-1
Part 1604858-01
E
2013 Nordson Corporation
Section 4
Operation
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation.
WARNING: This equipment can be dangerous unless it is used accordance
with the rules laid down in this manual.
WARNING: All electrically conductive equipment in the spray area must be
grounded. Ungrounded or poorly grounded equipment can store an
electrostatic charge which can give personnel a severe shock or arc and
cause a fire or explosion.
Controller Interface
See Figure 4-1. Use the controller interface to make spray settings and
monitor system operation. Refer to Setup for configuration settings.
Low Power Mode
Pressing and holding the Enable/Disable button for three seconds puts the
gun controller to sleep (low power mode). The displays and LEDs dim
completely.
A momentary press of the Enable/Disable button wakes up the gun
controller.
Gun Triggering
External Trigger Mode: If the gun controllers are configured for external
triggering, the guns are turned on and off by a signal from a PLC or other
device. An individual gun can be disabled for one trigger cycle by pressing
its controller’s Enable/Disable button. This allows the operator to turn off
unneeded guns for a particular part.
Continuous Trigger Mode: If the gun controllers are configured for
continuous triggering, use the Enable/Disable buttons to turn the guns on
and off.
Trigger All: For a multi-gun controller, the Trigger All switch can be used to
turn all guns on or off.