Nordson Encore LT Automatic, Customer Product Manual

Page: 23 / 71

System Setup
3-3
Part 1604858-01
E
2013 Nordson Corporation
Single/Dual Controller Mounting
Mount the controller on a flat surface with enough clearance around it to
connect the power, air, and gun cable to the rear panel. Refer to Figure 3-4
for dimensions.
WARNING: Connect the ground wire shipped with the controller to the
ground stud on the rear panel. Clamp the ground wire to a true earth
ground.
Dual Controller Optional Wall Mounting Kit
The optional wall mounting kit consists of a swiveling wall mounting bracket,
stacking brackets if installing two controllers, fasteners, and ground wires.
5. See Figure 3-3. Install the wall mounting bracket (5) on a vertical surface
strong enough to bear the weight of the controller(s) and mounting
bracket. Use appropriate fasteners.
6. Install a controller on the bracket tray and line up the holes in the
enclosure with the holes in the tray flanges.
7. If installing only one controller, secure it to the bracket flanges with four
M5 x 12 pan head screws (2).
8. If installing two controllers, use four M5 x 12 pan head screws (2) to
install the slotted ends of the stacking brackets (1) and controller to the
tray. Do not tighten the screws.
9. Place the second controller on top of the first controller, adjust the
stacking brackets to line up the screw holes, then secure the stacking
brackets to the top controller with four M5 x 12 pan head screws.
Tighten the bottom screws.
10. Use one 12-in. ground wire (3) to ground the top controller to the bottom
controller. Use the 4-in. ground wire (4) to ground the bottom controller
to the wall mount tray. Use the other 12-in. ground wire to connect the
tray to the mounting plate.
11. Loosen the tray swivel bolt (6) to rotate the tray to the desired position,
then tighten the bolt.