Super Claws Model LS-2
OPERATION/SHUTDOWN
MAR/2006 (4945-3500)
Section 4-5
AFTER OPERATION
Normal Shutdown
1. Hold the "CLAW PIN/FRAME PIN" switch in
the
UP (CLAW PIN)
position until the Claw
Housing lockpins can be installed.
2. Hold the "CLAW PIN/FRAME PIN" switch in
the
DOWN (FRAME PIN)
position until the
frame lockpins can be installed.
3. Make certain propulsion lever is in the
neutral position (released), and turn ignition
key to the full left (OFF) position.
4. Return all switches to their "Pre-Operational"
state using the Pre-Operational Checklist as
a guide.
5. Replace the operator hand control covers,
lower logic box cover, and secure them with
padlocks.
6. Turn off battery disconnect switch. Lock
battery box.
Parking or Locating Machine
1. Park or locate machine on level track area, if
possible; and where it will not be exposed to
excessive dust.
2. If the machine was towed, disconnect towing
vehicle and set the brakes. Move the towing
vehicle well clear of the parked machine.
Rotating Machine
The machine has a turntable which allows the
machine to be lifted off of the tracks and rotated.
The only function of this turntable is to rotate the
machine.
To lift and rotate the machine, proceed with the
following steps:
1. Center turntable base across two solid and
level ties.
2. Unhook sling from turntable base.
3. Unlock set-off valve handle. Slowly lift
handle to lower turntable until it comes into
contact with the ties.
4. Move the Turntable Valve hand lever upward
and hold until the machine is fully raised off
the track. Center the hand lever.
5. Use manpower to rotate the machine. The
wheels should be directly above the track
after rotating the machine.
6. Slowly move the Set-Off Valve hand lever
downward. The Turntable Cylinder will
retract and the machine will lower onto the
track.
Towing
Maximum towing speed is 20 mph. Reduce
speed accordingly as dictated by weather or
track conditions.
Remember that the machine weight may
approach the weight of the towing vehicle.
Maintain increased stopping distance
accordingly.
The following steps must be taken before towing
your machine:
1. Install Lock-Ups. See LOCK-UPS section.
2. Make certain turntable has been raised.
3. Remove drive chain(s) if machine is to be
towed a long distance.
4. Inspect the towing vehicle coupler for
damage or loose parts.
5. Back towing vehicle to the machine and
engage the couplers. Keep hands and
fingers clear of the coupling device and all
other pinch points.
6. Ensure that the coupling device is fully
engaged, closed, and locked.
7. Install Brake Lock Pins. See Brake
Assembly in Maintenance and Service for
instructions on installing brake lock pins.
8. Ensure that the coupling device and rear
frame members on the towing vehicles will
not interfere with or restrict motion of any
part of the machine when maneuvering.
9. When towing is complete, engage brake by
removing the Brake Lock Pins.
Summary of Contents for Super Claws LS-2
Page 2: ......
Page 16: ...GENERAL Super Claws Model LS 2 Section 2 4 MAR 2006 4945 3500 Page Intentionally Left Blank ...
Page 76: ......