30
ROP
4.8
E
LECTRICAL
I
NSTALLATION
1.
Install the UC4+ Control Panel (
E01
) in the
cab of the sprayer. Mount the panel where
it will be clearly visible and within easy reach
of the operator.
A good spot to mount the UC4+ control
panel is on the right hand side of the cab to
the Roll Over Protection Bar (ROP). Four
pilot holes for the screws provided need to
be drilled to facilitate the control panel
mounting.
If desired, a mounting bracket (part #A53255)
can be purchased from your local John Deere
dealer to allow the UC4+ control panel to be
mounted to the existing John Deere terminal
mount. Another option is to purchase an
adapter for the flexible panel mount that has a
3/8" NC threaded stud on the end to bolt
through the existing JD mount. You can find
these at your local outdoor store as a RAM
mount part number RAM-B-236. (See
http://www.ram-mount.com/
)
Figure 39 – Control Panel Mounting
Figure 40 – JD Control Panel Mounting
ROP
Summary of Contents for UC4+
