Norac UC4+, Installation Manual

Page: 21 / 50

18
2. Remove the rubber bumpers on both
ends of the roll frame (
Figure 18 ).
3. Install the frame target ( B07 ) onto the
parallel lift frame. The mounting bolt
should be close to the vertical member
of the frame facing forwards. See Figure
17
and Figure 18.
4. The frame target should be 41” (104cm)
from the bottom of the sensor as
shown in
Figure 18 .
The frame target (B07) should
be mounted to a frame
member that does NOT rotate
with the boom.
5. Install the spring target ( B12 ) onto the
boom center section 16” (41cm) down
from the bottom of the sensor as
shown in
Figure 19 .
The spring target (B12) must
be mounted to a frame
member that does move with
the boom.
Figure 19 – Target Location
6. Assemble the roll sensor mounting
bracket as shown in
Figure 20 .
7. Install the roll sensor bracket on the T-
shaped black intermediate frame, as
shown in (
Figure 19 ). The required
mounting hardware is included with the
bracket.
The bracket rod is designed to
slide in the bracket collar to
allow for sensor alignment
required in Step 8.
The sensor should be mounted
between the parallel lift arms and
the wheel in a position that will
not interfere with folding.
The sensor should not be behind
the wheel.
Figure 20 – Roll Sensor Mounting
Bracket
Mount Frame
Target as close
to the vertical
member as
possible.