Nokia Mobile Phones NSE-5 Series, Service Manual, Page: 108 / 327

PAMS
Technical Documentation
NSE–5
Service Software Instructions
Page 8
Issue 1 07/99
Equipment Setup
Caution: Make sure that you have switched off the PC and the printer
before making connections!
Caution: Do not connect the PKD-1 key to the serial port. You may
damage your PKD-1!
Attach the protection key PKD-1 to parallel port one (25-pin female
D-connector) of the PC. When connecting the PKD-1 to the parallel port
be sure that you insert the PC end of the PKD-1 to the PC (male side). If
you use a printer on parallel port one, place the PKD-1 between the PC
and your printer cable.
Next connect the M2BUS service cable, DAU-9P, to the serial port
(RS-232) of the computer. Attach one end of the service cable to the PC
serial port and the other end to the service box, JBA-4. For servicing the
phone with the covers in place the service box should always be used.
When the phone covers are removed the jigs should be used.
For audio measurements connect the audio cable, ADS-1, as follows:
-
EAR line to AF INPUT of test equipment
-
MIC line to MOD GEN OUTPUT of test equipment
Installation
Mechanical Connections
The software controls the phone via a separate adapter connected to the
serial port of the PC, and to the telephone’s M2BUS (DAU–9P).
Attach the dongle PKD–1 to the parallel port 1 (25–pin female
D–connector) of the PC. When connecting PKD–1 to the parallel port, be
sure that you insert the computer side of the PKD–1 to the PC (male side).
If you use a printer on parallel port 1, install the PKD–1 between the PC
and your printer cable.
The PKD–1 should not affect devices working with it. If some errors occur
(errors in printing are possible) please try printing without the PKD–1. If
printing is OK without the PKD–1 please contact your dealer. We will offer
you a new PKD–1 in exchange for your old one.