Use and Maintenance Manual model “H17 V LIGHT”
28
ENGLISH
1
2
12.2 AUGER LOADING FUNCTION
OK
OK
12.3 PELLET/AIR-INTAKE RATIO
OPERATING PROCEDURE:
MENU >> USER>> AUGER LOADING
Access the menu by pressing key
Scroll the entries to USER with the key
OK
To edit the switch on/off times, as well as enabling
the days of the week, press keys
Confirm each data change using the key and
move on to the second screen of the TIMER program.
The screen in the figure below shows the settings
options for both desired room temperature and
maximum boiler-water temperature during the
activation of the time frame . It is also possible to
control the ventilation speed (if applicable) .
OK
1
2
Edit the values using the keys
Confirm each data change using the
key until you exit the program.
OK
While editing, remember the following:
• press to return to the previous data, without
saving the last data changed;
•
if you intend to change one single datum, once the
change has been made, press multiple times until
you exit the function.
To return to the STAND-BY screen, press repeatedly.
OK
This function is necessary to facilitate the switch on
phase of the appliance, after accurate cleaning of
the hopper (pellet container) to remove sawdust -
which accumulates on its base over time - has been
carried out. See the chapter “Routine maintenance
of the product” for further info.
Also, make sure that pellets have been properly load-
ed in the tank and that the appliance is in the “OFF”
or “FINAL CLEANING” status before activating this
function.
The number - expressed in seconds - indicates the ro-
tation time of the auger during the loading phase.
After this time is up, the auger stops automatically,
and the appliance can switch on.
Access the menu by pressing
Scroll the entries to AUGER LOADING and press
Access the function by pressing key
The cleaner activates (for models equipped with
automatic cleaning) and then pellet loading is
enabled. The display will show a countdown: as it
reaches “0“, the loading will stop.
OK
At the end of the loading phase, the appliance will
show the USER screen.
The PELLET/AIR-INTAKE RATIO settings allow you to
change, with immediate effect, the quantity of pel-
lets loaded in the brazier and the quantity of air in-
bound of the product, tested and inspected with DIN
PLUS certified pellets. If you use other pellets or uncer
-
tified pellets, combustion may need to be adjusted.
Normally, the change is performed on the EXTRAC-
TION percentage to improve combustion; if oxygen
adjustment is not efficient, you may need to also
change the percentage of PELLETS falling.
OPERATING PROCEDURE:
MENU >> USER>> P/A RATIO
Access the menu by pressing key
Scroll the entries to USER, key
Access the menu by pressing key
Scroll the entries to P/A RATIO with the key
Access the function by pressing key
OK
OK
OK
OK
After the initial loading phase, a POPUP will appe-
ar, indicating the sucking of pellets from the brazier.
This operation does not allow emptying the pellets
into the ash drawer when the plate is rotating during
ignition.
Always vacuum the brazier using an ash cleaner.
FIRE HAZARD.
