NKT Photonics Koheras ADJUSTIK HP, Product Manual

Page: 79 / 115

79
CONTROL settings
the same port for transmission as for reception (i.e. as configured under the
System port ). Default setting is 0. If Local port in CONTROL’s Ethernet connection
is configured different than the Remote port , the computer’s port should match
the Remote port .
MAC Address
The MAC address for the laser’s Ethernet frames is shown in the bottom of the
Ethernet settings. The MAC address is not configurable but unique for every
laser.
Figure 47 Ethernet setting
Watchdog
The laser features a watchdog for monitoring of USB or Ethernet communication.
If CONTROL is disconnected from the chassis, the watchdog disables emission
after its timeout expires.
Enable Watchdog
To turn the watchdog on, select ON from the drop-down menu next to Enable
watchdog . To turn the watchdog off, select OFF.
Watchdog timeout
When CONTROL communications is disconnected, the Watchdog timer starts.
When it reaches the Watchdog timeout setting, emission is disabled. Set Enable
Watchdog to ON to enable the feature.