NKT Photonics Koheras ADJUSTIK HP, Product Manual

Page: 27 / 115

27
Front and rear panels
Figure 3 ADJUSTIK HP front panel layout
1
Rack mounting
There is a flange on the left and right sides of the front panel for mounting the laser in
a standard 19-inch rack. The flanges include plastic finger-grips to facilitate installing
and removing the laser from a rack. For more information on installing the laser, see
“Mechanical Installation” on page 87
.
Rear panel
Figure 4
shows the rear panel which includes the following connectors:
•
AC mains inlet - standard IEC C-14 mains inlet connector
•
LEMO connector - 2 pin door interlock circuit
•
Modulation – Male DB-9 pin connector providing pins for wavelength input/
output, amplitude modulation input and trigger signals
•
Ethernet – 10/100 Mbps BASE-T Ethernet port for IP connectivity to the laser
•
External Bus
Female DB-15 pin connector
– connects the laser to other systems or
accessories. The connector provides RS-485 bus control interface, 12V DC
power and an extension of the interlock safety circuit for connected
accessories. If no accessories are connected, the supplied bus defeater must
1. The ADJUSTIK controls and panel layout are identical
1 Optical output (main fiber output) 7 Keyswitch
2 Monitor optical output 8 Rack mounting flange and finger-grip
3 USB serial connector 9 Menu button
4 LCD display panel 10 Selection dial
5 Menu return button 11 Emission button
6 Status LEDs 12 AC mains switch
1 2 3 4 5 6 7
9 10
12 11 8
8