NKT Photonics Koheras ACOUSTIK, Product Manual

Page: 66 / 96

CONTROL settings
66
Figure 29: Wavelength modulation - module source selection
4. If the BASIK module is set to Internal , go to step 8.
5. For BASIK modules set to External or Both , select and highlight the
ACOUSTIK system in the device selector panel.
6. From the Settings (gear) drop-down menu, select Wavelength modulation .
7. Set the modulation signal source for the ACOUSTIK controller to either
External or Internal . See Figure 30 .
•
Internal – The system wavelength modulation signal lines (backplane bus)
transmit the ACOUSTIK’s internal function generator signal to the wavelength
input of each inserted BASIK module.
•
External – The system wavelength modulation signal lines (backplane bus)
transmit the external signal connected to the Wavelength± pins of the D-sub
9 pin connector on the rear panel of the ACOUSTIK to each inserted BASIK
module.
Figure 30: Wavelength modulation - ACOUSTIK source selected
8. End