Nitto TGF450 Series, User Manual, Page: 24 / 47

User’s Manual
Rev1.0
Date:15/07/2015 User’s Manual
24 / 47
Code setting
address
Item Code Description of code
C36
Last paratmeter
displayed in circle
display
00~05 Same as above
C40
The date sequence of
IEEE formate float of
Modbus
01
Lower 16bits address in front, the lower 8bits in the 16bits
address in front
02
Higher 16bits address in front, the Higher 8bits in the
16bits address in front
03
Lower 16bits address in front, the higher 8bits in the 16bits
address in front
04
Higher 16bits address in front, the lower 8bits in the 16bits
address in front
C41 Shape of pipeline
00 Round pipeline(D:D010)
01 Rectangel pipeline(L:D018 W:D019)
C47 Set password
00 Keep the password
01 Change the pass word
C49 Status
00 Working status
01 4~20mA output calibration statues
02 Flow rate calibration statues
03 Temperature calibration statues
04 Pressure calibration statues
C50 Total flow reset
00 Reset total flow to 0
01 Default
C60
Restore to backup
date
06 Restore to backup date
C61 Save setting backup 16 Save current setting for backup
C80
Version No. of
hardware
Read Only
C81
Version No. of
software
Read Only
C82 Calibration date Read Only
C83 Number of errors Read Only
C84
Version No. of
HART
Read Only
C86
Communication
interface
00 Modbus Read Only
01 Hart Read Only
C87 Pressure sensor type
00 No pressure sensor Read Only
01 Piezo Read Only
02 Piezo Read Only
03 4~20mA Read Only
04 0~10mA Read Only
C88 Product ID No. Read Only
Note:
1) If the unit of flow rate is changed or measurement changed from flow rate to mass flow, users can
reset the total flow to 0 or record the current total flow, as the number of total flow will not change
according to unit.
2) Total flow can only be output by pulse, temperature and pressure can only be output by frequency